Hello to my favorite people!! need help with air system, question is what air valves do I need to keep drivers side under electric panel? Have no air door, no over the road air, no air wipers, trying to keep it simple? I have a 84 eagle 10 6v92, 740 tranny. Thankyou for all the help! Richard

Hi there Richard, I have an 89-15 the only accy I have left is the air wipers, nipped the rest of the lines @ the aux tank. Can you post a photo of what is left in the bottom of the panel? so's we can see what all is left over that can be eliminated

Van

Thanks Van, but everything is out now (rebuilding) I will get list and picts if I can, I'm sure the quick release valves for door can go but not sure what else? Thankyou so much, will post info as soon as I can, Richard

Richard, this is a copy of the response I posted on the BCM forum,
Hi Richard, I just did this the other week, I have some photo's but they are out of focus. All the lines you will need to disconnect come from the Auxiliary tank. I started by properly (as BW said) capping off the supply lines from the Aux tank up front one line ( line 51 from aux tank) does the loop through the door system, line 51 feeds the wipers, the other ( line 90 from aux tank)goes to the air filter ( bottom of front elec panel) then to the Gradustat and on to the AC Modulation valve both in the rear luggage bay, that is pretty much it. Make sure that you double check the routing of these lines to be sure they are the correct ones before disconnecting. I hope this helps, will try and get over to take some descent photos of my panel today.

Van Grin

Van, Thankyou so much for all the help!! I will keep posting with more info as it comes up. Thanks again, Richard

Here is the schematic on the inside of the door, if you save image as' the picture you'll be able to zoom in on it

And as you can see, although my lines are already disconnected at the aux tank, I have yet to start weeding out the unneeded items too


Van

Thankyou Van for the info and pictures, great help!! I will double check the air lines and remove, thankyou again, Richard

Van, You should post that schematic in the Tech section. That is a good thing to have available to those who need to look at it. That's the first real one I've seen!

Paul I was in a rush when I snapped that shot yesterday, I will get a better one today or tomorrow, maybe we can clean it up a bit. good lookin out